
Who needs the air brakes test
California's handbook says the air brakes test is required for drivers of vehicles with air brakes, including air over hydraulic brakes. Federal rules count as air brakes any braking system operating fully or partially on the air brake principle. If the truck or bus you will drive, or take the skills test in, has air brakes, you need this test.
| State | Questions | Correct to pass |
|---|---|---|
| Washington | 25 | 20 |
| Utah | 25 | 80% (20) |
The pass mark everywhere is at least 80%, and the test is scored separately from general knowledge. The rest of the permit process is on our CDL practice test page.
What the written test covers
Federal rules list the air brake knowledge every applicant needs (49 CFR 383.111(b)): system nomenclature; the dangers of a contaminated air supply (dirt, moisture and oil); what severed or disconnected air lines between tractor and trailer mean; what low pressure readings mean; pre-trip inspection of fail-safe devices, monitoring devices and low pressure alarms; en route and post-trip tests of air loss and of the pressures at which the low-air warning and the tractor protection valve should activate; and braking technique, antilock brakes, emergency stops and the parking brake.
In the manuals this is Section 5, "Air Brakes", in four parts: the parts of an air brake system, dual air brakes, inspecting air brake systems, and using air brakes (New York; California). New York tells air brakes candidates to study Section 5, and combination candidates to study Sections 5 and 6, so trailer air brakes reappear on the combination test.
If you skip or fail it: the L restriction
You can still get a permit without passing air brakes, but with a restriction. If you fail the air brake knowledge test, or take the skills test in a vehicle without air brakes, the state must mark your CLP or CDL as restricted from operating a CMV equipped with any type of air brakes. The code is L, "No air brake equipped CMV" (49 CFR 383.153).
A related code, Z, "No full air brake equipped CMV", goes on the license of someone who took the skills test in a vehicle with air-over-hydraulic brakes. Both restrictions, and the other codes, are explained in CDL endorsements and restrictions.
To remove L or Z later, you do not retake the full skills test. The state may give a modified skills test, and you must also perform the air brake pre-trip inspection and pass the air brake knowledge test.

The air brake check on the skills test
On the vehicle inspection part of the skills test, federal rules require you to show that you can, among other things, check the low pressure warning devices, confirm the system keeps an adequate air supply, check that build-up time is within limits and that alarms and emergency devices work at the right pressure, and check the brakes' performance (49 CFR 383.113(a)(2)).
The stakes are high. New York says failing to perform all three parts of the in-cab air brake check correctly is an automatic failure of the vehicle inspection test. California says that if its required items are not demonstrated and their limits not said aloud correctly, it is an automatic failure of that part. Our pre-trip inspection guide covers the rest of that test.
About the "7-step air brake test"
You will see the phrase "7-step air brake test" online. The manuals do not number the air brake checks from 1 to 7. They teach a 7-step vehicle inspection method, and the air brake checks are its last step, "Step 7: Final Air Brake Check" (section 5.3.3 in both the California and New York manuals), done instead of the hydraulic brake check.
The checks and their limits
These limits appear in section 5.3.3 of both manuals, with the same figures unless noted.
| Check | How | Limit (California and New York) |
|---|---|---|
| Rate of air pressure build-up | Engine at operating rpm (CA: normal idle, 600-900 rpm) | Dual air system: from 85 to 100 psi within 45 seconds. Single system (pre-1975): 50 to 90 psi within 3 minutes |
| Air leakage, brakes released (static) | Fully charged system, engine off, brakes released, time 1 minute | Single vehicle: 2 psi (NY: less than 2). Combination of 2: 3 psi (NY: less than 3). California adds 5 psi for 3 or more vehicles |
| Air leakage, brakes applied | Engine off, foot brake fully applied and held 1 minute after the gauge settles (NY: apply 90 psi or more) | Single vehicle: 3 psi. Combination: 4 psi. California adds 6 psi for 3 or more vehicles |
| Spring brakes come on automatically | Fan off air by pumping the brake pedal | Tractor protection valve and parking brake valve pop out, normally between 20 and 45 psi (or the manufacturer's level) |
| Parking brake | Gently pull against it in a low gear | It must hold |
| Service brakes | About 5 mph, brake firmly | No pulling to one side, no odd pedal feel or delay |
California adds a note for combinations where the trailer has electric or surge brakes rather than air: the applied leakage limit is 3 psi, and the released limit for a combination is 2 psi if the towed vehicles have no air brakes (California handbook, 5.3.3).
Where the manuals disagree: the low-air warning
The low pressure warning (buzzer, light or wig-wag) must come on as pressure falls, but the two manuals give different numbers:
- California: before air pressure drops below 55 psi, or the level the manufacturer specifies (California handbook, 5.3.3).
- New York: before pressure drops to less than 60 psi in the air tank, or the tank with the lowest pressure in a dual system (New York manual, 5.3.3).
Both note that on large buses the warning commonly comes on at 80-85 psi. Learn the figure in your own state's manual, because you will be asked to say it.
The governor also differs by manual. New York says the compressor should cut in at about 100 psi and cut out at about 125 psi, while California's applied leakage test starts at governor cut-out of 120-140 psi; both defer to the manufacturer's specification. And New York's pre-trip test section describes the tractor protection and parking brake valves popping out "at approximately 40 psi", inside the 20-45 psi range of its Section 5.
How to prepare
- Read Section 5 of your state's manual twice, once for the parts (compressor, governor, tanks, drains, safety valve, gauges, spring brakes) and once for the checks.
- Learn the numbers as pairs: build-up 85 to 100 in 45 seconds; leakage 2 and 3 released, 3 and 4 applied; spring brakes 20 to 45; your state's low-air figure.
- Answer the end-of-section review questions; both manuals say such questions may be on your test.
- Practice the check in a real cab with your trainer, saying each limit aloud.
Our air brakes practice questions are original, written from the state manuals and federal rules. The CDL practice pack includes full 25-question air brakes sets alongside general knowledge and combination vehicles. The general knowledge test guide explains how the three tests fit together, and entry-level driver training covers the training you need before the skills test.
More CDL Knowledge Tests guides
Entry-level driver training (ELDT): who needs it and when
Who needs CDL entry-level driver training since February 7, 2022, what theory and behind-the-wheel training involve, the 80% assessment and the provider registry.
Published November 9, 2026
CDL pre-trip inspection: how the vehicle inspection test works
How the CDL pre-trip (vehicle inspection) test works, what to check and say at each part of the truck, the numbers to know and the daily inspection rules.
Published November 5, 2026
CDL Class A vs Class B: what each license lets you drive
The federal definitions of Class A and Class B CDLs (26,001 lb and the 10,000 lb trailer rule), what each lets you drive, the tests each needs and the ELDT rule.
Published October 29, 2026
CDL endorsements and restrictions explained
What each CDL endorsement allows, which tests it needs, the TSA check and training for hazmat, and what restriction codes such as L, Z, E and O mean on a license.
Published October 25, 2026
CDL general knowledge test: questions, topics and passing score
How many questions are on the CDL general knowledge test, the 80% rule, what the test covers by manual section and which other permit tests your license class needs.
Published October 21, 2026
New on passmock
The Next Generation NCLEX, explained
What the Next Generation NCLEX changed in 2023: the six-step clinical judgment model, case studies and stand-alone items, partial-credit scoring, and how to prepare.
Published November 10, 2026
CSCS test revision: what is tested and how to revise
What the CITB HS&E (CSCS) test covers, how its questions work since 2019, the official GT100 book and app, and a realistic plan for the 90% pass mark.
Published November 8, 2026
How many questions are on the CNA exam, and how long is it?
CNA exam length by state: 70 questions in 2 hours on the NNAAP, 60 in 90 minutes with Prometric, 75 in Tennessee, 79 in Ohio, plus the skills test time.
Published November 7, 2026
Sources
- 49 CFR 383.95, Restrictions — eCFR (checked October 3, 2026)
- 49 CFR 383.135, Passing knowledge and skills tests — eCFR (checked October 3, 2026)
- 49 CFR 383.111, Required knowledge (air brakes) — eCFR (checked October 3, 2026)
- 49 CFR 383.113, Required skills (air brake inspection) — eCFR (checked October 3, 2026)
- 49 CFR 383.153, Information on the CLP and CDL documents — eCFR (checked October 3, 2026)
- CDL knowledge test — Washington State Department of Licensing (checked October 3, 2026)
- CDL Written Knowledge Test — Utah Driver License Division (checked October 3, 2026)
- California Commercial Driver Handbook, Section 5 Air Brakes — California DMV (checked October 3, 2026)
- New York State Commercial Driver's Manual (CDL-10), Section 5 Air Brakes — NYS DMV (checked October 3, 2026)
- New York State Commercial Driver's Manual (CDL-10), Sections 11-13 — NYS DMV (checked October 3, 2026)
- New York State Commercial Driver's Manual (CDL-10), Section 1 — NYS DMV (checked October 3, 2026)
passmock is an independent practice service. It is not affiliated with or endorsed by the Federal Motor Carrier Safety Administration (FMCSA), the U.S. Department of Transportation, the American Association of Motor Vehicle Administrators (AAMVA) or any state DMV, DPS or driver licensing agency. Our questions are original practice questions written from the official state CDL manuals and federal regulations; they are not taken from any state's test.
Short on time? A professional can help
Prefer to work with a professional? A tutor, a prep course or a driving school: we can pass your request to up to 3 partners. Free, no obligation; passmock does not teach. How to choose.